![]() The alarm control is located in Controller Properties. However, be aware that this process requires a server reboot in order to access the WebBIOS. ![]() ![]() You can also silence the alarm in the LSI MegaRAID BIOS Config Utility. Run this command in MegaCLI in order to silence the alarm: # MegaCli -AdpSetProp -AlarmSilence -aALL.Refer to the LSI Documents & Downloadspage in order to locate documentation on this procedure. If you want to avoid an LSI firmware upgrade, you can complete these steps in order to resolve this issue: This issue affects any server vendor that uses these adapters (for example, Cisco, HP, and Dell). Note: TheLSI defect is reported as fixed in MegaRaid firmware 21.0.1-0111 and 21.0.1-0110. MegaRAID Firmware Release notes for more information on this bug. Users can deploy the MegaRAID SAS 9266-4i controller in existing HDD-based server environments for significant performance gains. If there are no failed drives reported by the Cisco Integrated Management Controller (CIMC), this problem might occur due to an issue described in this LSI MegaRaid firmware bug: LSIP200139764. The MegaRAID SAS 9266-4i controller, with four internal ports, delivers two 800MHz PowerPC processor cores and a 72-bit DDRIII interface that drives 1GB cache memory. Refer to LSI MegaRAID Card Beep Codes in the Cisco UCS Servers RAID Guide in order to view the beep codes. You can view the LSI MegaRAID Card Beep Codes in order to identify the specific alarm. This document describes an issue that causes a Cisco Unified Computing System (UCS) server to beep continuously.Ī Cisco UCS server beeps continuously this beep originates from the LSI RAID adapter.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |